World Pay Error 80040154 - Retrieving the Com class factory...
"Retrieving the Com class factory..."
"Error 800401154"
This error means you don't have Client Control installed.The link will be on the dealer setup letter, it is the same link that takes you to the NetEpay installer.
Related Articles
World Pay Credit Card Processing Error : Does not Accept Record No.
Reach out to World Pay and and ask them to turn on Tokenization.World Pay Chip Reader Setup
World Pay Chip Reader Setup 1. Plug in device + power 2. Load driver for VX805 USBUART (in the ftp, under tech stuff>drivers>vx805 usbuart) If the device is properly connected to the station you will see an alert stating that the driver was installed ...World Pay Chip Reader Error: Invalid Field Lane ID
Verify that the value for CCProcessingTerminalID is blank in station config and you have the correct value in NetEpayDeviceID. If you made a change to any of these settings initialize the keypad once more in back office>credit cards>Initialize ...Moving World Pay Chip Reader to New station or hard drive
If a client needs a chip reader re-programmed for a new station or onto the same station with a new hard drive the chip reader will need to be decoupled. Ask the client for the serial number and then email channelsupport@worldpay.com and CC ...WorldPay/Vantiv CC Issue - Status: Reply Error Error: Error Processing Web Service Transaction. No reply from mercury server. The underlying connection was closed.
Status: Reply Error Error: Error Processing Web Service Transaction. No reply from mercury server. The underlying connection was closed. This is caused by pizza cloud content filtering, an exception needs to be added for that station on the pepwave.